Timer3, Timer4 and Timer5 are all 16bit timers, similar to Timer1.Īll timers depends on the system clock of your Arduino system. First 3 timers (Timer 0, Timer1 and Timer2) are identical to the ATmega168/328. They are almost identical to previous chips but only differs in memory size. The Arduino Mega series is based on the Atmel AVR ATmega1280 or the ATmega2560. 8bits means 256 values (two to the power of 8) where 16bit means 65536 values (two to the power of 16) which is much higher resolution. The most important difference between 8bit and 16bit timer is the timer resolution. Timer0 and Timer2 are 8bit timer, where Timer1 is a 16bit timer. Both have 3 timers, called Timer0, Timer1 and Timer2. These chips are pin compatible and only differ in the size of internal memory. The Arduino board is based on the Atmel AVR ATmega168 or the ATmega328 microchip. You can configure the pre-scaler for the timer, or the mode of operation and many other things. The timer can be programmed by some special registers. It is like a clock, and can be used to measure time events. counter is a piece of hardware built in the Arduino controller. Buy the Arduino from: Banggood | Amazon What is a timer?Ī timer, A.K.A.

Capteur tor definition